LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1449 of 1904 2022-03-04
If socket is connected an error code is reported.
in case of CA Certificate already stored(for instance: SUPL), it
could be possible to avoid #SSLSECDATA command.
Once the <Password> saved, changing password is not allowed. To
reset <password>, it can use AT#SSLSECDATA=1,0,2.
Maximum <size> for Certificate/ RSA Private key is 4096 bytes.
Only CA Certificate can support up to 12228 bytes in case of PEM
format.
If CA Certificate has a format to DER, it can be limited as 4096
bytes too.
The CA certificate chain can store 1 Root CA and up to 2
Intermediate CA and it is saved in NVM memory.
This module can be supported PKCS 1 type of RSA Private key.
AT#SSLSECDATA?
Read command reports what security data are stored in the format:
#SSLSECDATA: <SSId>
,<CertIsSet>,<CAcertIsSet>,<PrivKeyIsSet>
<CertIsSet>, <CAce
rtIsSet>, <PrivKeyIsset>
are 1 if related data are stored into NVM otherwise 0.
AT#SSLSECDATA=?
Test command returns the range of supported values for all the
parameters:
#SSLSECDATA: (1),(0-2),(0,2),(1-4096),(10)
#SSLSECDATA: (1),(0-2),(1),(1-12228),(10)
To Next Page
Loading...
Need help?
General
