Telit Wireless Solutions LE910C series - Page 1454

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1454 of 1904 2022-03-04
Not Subject to NDA
If <DataType>, <Index> data has not been stored (or it has been
deleted) the response has the following format:
#SSLSECDATAEXT: <connId>,<DataType>,<Index>
No data stored
OK
<size> parameter is mandatory if the <write> action is issued, but it
has to be omitted for <delete> or <read> or <select> actions are
issued.
if secure socket is not enabled using AT#SSLEN only test requests
can be made.
If socket is connected an error code is reported.
Maximum supported number of CA certificate is up to 3.
To use for H/S procedure, you need to choose <Action> to 3("Select
data from NVM).
No chained CA certificates are supported.
AT#SSLSECDATAEXT?
Read command reports what security data are stored in the format:
#SSLSECDATAEXT: <SSId>,<SelectedIndex>,<CAcert1Set>,< CAcert2Set
>,< CAcert3Set >
< SelectedIndex >,< CAcert1Set >, < CAcert2Set >, < CAcert3Set > are 1 if
related data are stored into NVM otherwise 0.
AT#SSLSECDATAEXT=?