LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1543 of 1904 2022-03-04
the command has to be issued from the TCP ATRUN instance.
After this command has been issued, if no error has occurred, then
a "CONNECT" will be returned by the module to advise that the
TCP ATRUN instance is in
online mode
and connected to the port
specified.
to exit from online mode and close the connection, the escape
sequence (+++) has to be sent on the TCP ATRUN instance.
The escape sequence needs to be sent in one single packet.
The use of Telnet for Windows sending every single byte in a TCP
packet is not appropriate to perform this connection.
AT#TCPATCONSER=?
Test command returns the supported values for the
TCPATCONSER parameters.
To Next Page
Loading...
