Telit Wireless Solutions LE910C series - Page 156

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 156 of 1904 2022-03-04
Not Subject to NDA
compatibility. Values shown by the indicators will be current
indicators values, not buffered ones. Subsequent +CMER
commands with <mode> different from 0 and <bfr> equal to 0 will
not flush the codes, even if <mode> was set again to 0 before. To
flush the codes, <bfr> must be set to 1.
Although it is possible to issue the command when SIM PIN is
pending, it will answer ERROR if "message" or "smsfull" indicators
are enabled in +CIND, because with pending PIN it is not possible
to give a correct indication about SMS status. To issue the
command when SIM PIN is pending you have to disable "message"
and "smsfull" indicators in +CIND first.
LE910Cx-EUX/SAX/SVX/WWX cannot be displayed sounder URC,
because it does not support audio playback
AT+CMER?
Read command returns the current setting of parameters, in the format:
+CMER: <mode>,<keyp>,<disp>,<ind>,<bfr>
AT+CMER=?
Test command returns the range of supported values for
parameters <mode>, <keyp>, <disp>, <ind>, <bfr>, in the format:
+CMER: (list of supported <mode>s),(list of supported <keyp>s), (list of
supported <disp>s),(list of supported <ind>s),(list of supported <bfr>s)