Telit Wireless Solutions LE910C series - Page 1577

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1577 of 1904 2022-03-04
Not Subject to NDA
<param_i>
string
-
indicating the i-th parameter
associated to the type specified
If the received data are the consequence of a previous data sending
issued by AT#DWSEND, then the <msgId> value is the same of the
<msgId> value reported in the answer of AT#DWSEND.
The incoming Server data are notified by the URC #DWRING with
the following format:
#DWRING: <type>,<msgId>,<len>
Name
Type
Default
Description
<type>
string
-
type of message to receive
<msgId>
integer
-
index of the data message to receive
<len>
integer
-
length of data message to receive
it is possible to use AT#DWRCV only if the connection has been
opened with AT#DWCONN, else the ME is raising an error.
If the data received are the consequence of a previous data sending
issued by AT#DWSEND, then they can be read only using
AT#DWRCV command and not AT#DWRCVR command (i.e.:
AT#DWRCV and AT#DWRCVR are not interchangeable).
AT#DWRCV=?
Test command reports the supported range of values for all parameters.