Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1585 of 1904 2022-03-04
Not Subject to NDA
<len>
integer
-
length of data message to receive
If the incoming data are accepted with AT#DWRCVR, then the data
are received and showed with the following URC:
#DWRDATA: <msgId>,<error>,<len>,<data>
Name
Type
Default
Description
<msgId>
integer
-
defined as Set section
<error>
integer
-
error code of the message to
receive, 0 if there is no error.
<len>
integer
-
defined as Set section
<data>
string
-
M2M Service data
it is possible to use AT#DWRCVR only if the connection has been
opened with AT#DWCONN, else the ME is raising an error.
If the data received are the consequence of a previous data sending
issued by AT#DWSENDR, then they can be read only using
AT#DWRCVR command and not AT#DWRCV command (i.e.:
AT#DWRCV and AT#DWRCVR are not interchangeable).
AT#DWRCVR=?
Test command reports the supported range of values for all parameters.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English