LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1594 of 1904 2022-03-04
contains a string, between
double quotes, with the host
software version identifier.
HSW0, default value
The odis setting requires all the odis values to be set each time the
command is issued, therefore, to change only one odis parameters it is
recommended to read all the values first, and then compose the command
input string accordingly.
Since the odis items are 4, it is quite unlikely but possible that some the
storing of some of them fails. In this case, the new values, where
succeeded, are kept. An advice is that, in case of storing failure, the
+ODIS? command is used to verify what are the odis items changed, if any.
This command is only valid on AT&T firmware, and not on other carriers
firmware.
AT+ODIS?
Read command reports the current odis values in the format:
+ODIS: <instance#0>,<hostManufacturer#0>,<hostModel#0>,<hostSwVersion#0>
+ODIS: <instance#1>,<hostManufacturer#1>,<hostModel#1>,<hostSwVersion#1>
As per AT&T specification, the <hostUniqueDevId> odis parameter could be
set but it cannot be read by AT commands.
AT+ODIS=?
Test command reports the supported range of values for all parameters
To Next Page
Loading...
