EasyManuals Logo

Telit Wireless Solutions LE910C series At Commands Reference Guide

Telit Wireless Solutions LE910C series
1904 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #16 background imageLoading...
Page #16 background image
LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 16 of 1904 2022-03-04
Not Subject to NDA
3.15.2. AT#ETHCFG - Ethernet LAN configuration 1092
3.15.3. AT#ETHIP - Return assigned IP address 1094
3.15.4. AT#ETHMODE - Change Ethernet Mode 1095
3.15.5. AT#ETHSTATUS - Link status of Ethernet 1097
3.15.6. AT#ETHEN - Enable/Disable ETH 1099
3.15.7. AT#USBZLPDIS - Configure Modem Ports for a host not sending ZLP 1102
3.15.8. AT+CBC - Battery Charge 1104
3.15.9. AT#TEMPCFG - Temperature Monitor Configuration 1107
3.15.10. AT#GPIO - General Purpose Input/Output Pin Control 1116
3.15.11. AT#ALARMPIN - Alarm Pin Configuration 1122
3.15.12. AT#SLED - STAT_LED GPIO Setting 1124
3.15.13. AT#SLEDSAV - Save STAT_LED GPIO Setting 1127
3.15.14. AT#SWREADYEN - SW READY ENable 1128
3.15.15. AT#ADC - Read Analog/Digital Converter Input 1130
3.15.16. AT#V24CFG - V24 Output Pins Configuration 1132
3.15.17. AT#V24 - V24 Output Pins Control 1135
3.15.18. AT#I2CWR - Write to I2C 1137
3.15.19. AT#I2CRD - Read from I2C 1140
3.15.20. AT#I2CCF - Combined Format for I2C Writing and Reading 1142
3.15.21. AT#SPIEN - Enable SPI Configuration 1144
3.15.22. AT#SPICFG - SPI Pins Configuration 1146
3.15.23. AT#HSICEN - Enable HSIC Configuration 1149
3.15.24. AT#RXDIV - Enable RX Diversity and Set DARP 1151
3.15.25. AT#GSMAD - GSM Antenna Detection 1153
3.15.26. AT#VAUX - Auxiliary Voltage Output Control 1158
3.15.27. AT#VAUXSAV - Auxiliary Voltage Output Save 1160
3.15.28. AT#TEMPMON - Temperature Monitor 1161
3.15.29. AT#QTEMP - Query Temperature Overflow 1164
3.15.30. AT#TESTMODE - Test Mode Configuration 1166
3.15.31. AT#RXTOGGLE - Swap RX from Main to Diversity 1180
3.15.32. AT#CBC - Battery and Charger Status 1183
3.15.33. AT#STUNEANT - Set Tunable Antenna Interface 1185
3.15.34. AT#SKIPGCF - SKIPGCF mode enable / disable for thermal test 1192
Mobile Broadband 1194
3.16.1. Ethernet Control Mode (ECM) 1194
3.16.1.1. AT#ECM - Ethernet Control Model Setup 1194
3.16.1.2. AT#ECMC - ECM Configure 1197
3.16.1.3. AT#ECMD - ECM Shutdown 1201
3.16.1.4. AT#RNDIS - Remote Network Driver Interface Specification setup 1203

Table of Contents

Other manuals for Telit Wireless Solutions LE910C series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Telit Wireless Solutions LE910C series and is the answer not in the manual?

Telit Wireless Solutions LE910C series Specifications

General IconGeneral
BrandTelit Wireless Solutions
ModelLE910C series
CategoryWireless modules
LanguageEnglish

Related product manuals