Telit Wireless Solutions LE910C series - Page 1602

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1602 of 1904 2022-03-04
Not Subject to NDA
1
:
hash mark printing enabled during injection every
4096 bytes (LE910Cx ThreadX only)
Send escape sequence +++ to end data transmission (which will
result in OK response).
In LE910Cx Linux, If <param1> parameter value was specified, the
command will report OK once all size is received.
In LE910Cx ThreadX, escape sequence detection (+++) works after
2 seconds from last data received. In escape sequence detection
mode, any other characters except escape sequence +++ will
return ERROR.
The following AT configurations restore to default value after FOTA
Update. It applies to both LE910CxLinux and LE910Cx ThreadX
Common profile section (See 3.3.1 Factory Profile and User
Profiles for details)
+WS46, +CEMODE, +CGSMS, #AUTOATT, #WKIO, #ENS,
#SCFGEXT3, #DNS, #HTTPCFG, $SLP, $LCSSLP, $SLPTYPE,
$SUPLSEC, $SUPLV, $LTC, $GPSLOCK, $AGPSEN, $LCSLPP,
#SMSMODE, #PLMNMODE, #BND, #SCFG, #AUTOBND,
#JDRENH2, #JDR4GCFG, #IMSPDPSET, $LCSAGLO, $GPSDPO,
#SSLCFG, #SSLSECCFG, #PROTOCOLCFG, $GPSELNA, #TXCAL,
#CALLDISA, #BCCHLOCK, #HOSTODIS, #TXCAL4G, #CLATENA,
#GTPEN, #ECALLNWTMR, #ECALLTMR, $XTRAEN,
#SINGLEAPNSWITCH, #ALLOWHAC, #ECALLURC, +CSCB,
#PKTSZ, #DSTO, #SKTTO, #SKTCT, +ODIS, #GPIO, #TEMPCFG,
#SIMINCFG
AT#OTAUPW=?
Test command returns OK result code.