Telit Wireless Solutions LE910C series - Page 1672

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1672 of 1904 2022-03-04
Not Subject to NDA
Bit 5
reserved, set it to 0
Bit 6
reserved, set it to 0
Bit 7
reserved, set it to 0
A reboot is needed for the setting to take effect.
AT$GNSSCONST?
Read command returns the active and requested configuration for
GNSSCONST.
$GNSSCONST: <active>,<requested>
Additional info:
Below the meanings of <active> and <requested> parameters:
Name
Type
Default
Description
<active>
integer
-
value showing the current active
status
<requested>
integer
-
value showing the requested
status that will be activated on
the next power ON
AT$GNSSCONST=?
Test command returns the supported range of values for <mask>.