Telit Wireless Solutions LE910C series - Page 1686

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1686 of 1904 2022-03-04
Not Subject to NDA
Read command returns the current SLP address <slp_address> and, if
address is not empty, the <slp_port_number> port number, in the format:
$SLP: <slp_address>[,<slp_port_number>]
If the FQDN is empty. the <slp_port_number> value is 0
AT$SLP=?
Test command returns the range of values in the following format:
$SLP: (0,1,3),("IP,URL,IPv6")