Telit Wireless Solutions LE910C series - Page 1696

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1696 of 1904 2022-03-04
Not Subject to NDA
In LE910Cx series models, the default value depends on operator
requirement.
- LE910C1-NA: 2
- LE910C1-NS: 3
- LE910Cx-AP: 1(KDDI), 3(Except for KDDI)
- LE910Cx-NF: 2(ATT), 3(VZW, TMO)
- LE910Cx-EU(X): 3
- LE910Cx-LA/CN: 2
- LE910C1-SV(X): 3
- LE910C1-ST: 3
- LE910C1-SA(X): 2
- LE910Cx-WWX: 3, 1(KDDI), 2(ATT)
AT$LCSLPP?
Read command returns the currently selected configuration for LPP
protocol in the format:
$LCSLPP: <mode>
AT$LCSLPP=?
Test command reports the supported range of values for parameter(s)
<mode>.
$LCSLPP: (the supported range of <mode>)