Telit Wireless Solutions LE910C series - Page 1698

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1698 of 1904 2022-03-04
Not Subject to NDA
The default value depends on operator.
For LM9x0 / LE910Cx series,
- AT&T: 1
- Others: 0
For Fx980/LN920 series,
- AT&T: 1
- Generic: 15
- Others: 0
AT$LCSAGLO?
Read command returns the currently selected protocol mask of A-
GLONASS in the format:
$LCSAGLO: <mask>
AT$LCSAGLO=?
Test command reports the supported range of values for parameter(s)
<mask>.
$LCSAGLO: (the supported range of <mask>)
This command is only applicable for A-GLONASS capable setting.
(see $AGPSEN)
The <mask> 4 and 8 must be set in the LPP configuration for this to
take effect. (see $LCSLPP)