Telit Wireless Solutions LE910C series - Page 1756

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1756 of 1904 2022-03-04
Not Subject to NDA
the value range, see the
GPRS Timer 3 IE in 3GPP TS
24.008.
<ReqActiveTime>
string
-
one byte in an 8 bit format.
Requested Active Time
value (T3324) to be allocated
to the UE. The requested
Active Time value is coded
as one byte (octet 3) of the
GPRS Timer 2 information
element coded as bit format
(e.g. "00100100" equals 4
minutes). For the coding
and the value range, see the
GPRS Timer 2 IE in 3GPP TS
24.008.
A special form of the command can be given as AT+CPSMS= (with all
parameters omitted). In this form, the parameter <mode> will be set to 0,
the use of PSM will be disabled and data for all parameters in command
+CPSMS will be removed or, if available, set to the manufacturer specific
default values.
CPSMS configuration is saved in the file system
The <Requested_Periodic-RAU> and <Requested_GPRS-READY-timer>
parameters are not supported in this module. In other words, these
parameters input values are ignored.
AT+CPSMS?
Read command returns the current CPSMS configuration, in the format:
+CPSMS:<mode>,[<ReqPeriodicRAU>],[<ReqGPRSreadyTimer>],[<ReqPeriodicTAU
>], [<ReqActiveTime>]