Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1760 of 1904 2022-03-04
Not Subject to NDA
- All configured values stored on module and applied after next
power cycle.
However, LE910C1-EUX/SAX/SVX and LE910Cx-WWX can be
applied immediately.
- The setting is not maintained after firmware update but
maintained when firmware switching.
- When <mode> is 1 or 3, doesn't power off by ON_OFF_N.
- When <mode> is 1 or 3, GPIO8 and GPIO10 are used as
W_DISABLE_N monitoring and VBUS control. Customer should not
use GPIO for other function.
- This command works only with mPCIe type and may cause
malfunction if set on other HW types such as LGA form factor.
AT#PSMWDISACFG?
Read command returns current mode.
AT#PSMWDISACFG=?
Test command reports the supported mode.
•
AT#PSMWDISACFG=3
OK
•
AT#PSMWDISACFG?
#PSMWDISACFG: 3
OK

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English