LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1769 of 1904 2022-03-04
file content is readable with #RSCRIPT
file content is hidden, #RSCRIPT command will
report empty
In case of this command on UART, DTE must use HW flow control
and AT+IFC=2,2 configured.
when sending the script be sure that the line terminator is
<CR><LF> and that your terminal program does not change it.
with the hidden attribute it is possible to protect your files from
being viewed and copied, only the file name can be viewed, its
content is hidden even if the file is still being run correctly.
It's your care to maintain knowledge on what the file contains.
AT#WSCRIPT=?
Test command returns OK result code.
AT#WSCRIPT="userdata.txt ",54,0
>>> here receives the prompt; then type or send the textual data, sized 54
bytes OK Textual data has been stored
OK
To Next Page
Loading...
