Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1848 of 1904 2022-03-04
Not Subject to NDA
This command returns 'CharactersiticID' used for
service data exchange.
Ex:AT#Battrib="charval","perm=0011","len=1","val=5
9"
4) "complete"
<type>="complete".
Used to signal that all attribute definitions have been
sent to the controller. This command returns
'ServiceID' used for service data exchange.
For Example: AT#Battrib="complete"
AT#BATTRIB=?
Test command reports supported range of values for all parameters.
To add a new service:
AT#BATTRIB="pserv","uuid=12AA"
OK
AT#BATTRIB="char","prop=1A","uuid=12A1"
OK
AT#BATTRIB="charval","perm=0011","len=1","val=59"
#BATTRIB: "CHARID: 2"
OK
where "CHARID: 2" is CharacteristicID with Hex value '2'
AT#BATTRIB="complete"
#BATTRIB: "SRVID: 0"
OK
where "SRVID: 0" is ServiceID with Hex value 0

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English