Telit Wireless Solutions LE910C series - Page 202

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 202 of 1904 2022-03-04
Not Subject to NDA
Note: DLC establishment on Virtual Channel between mode 0 and
mode 1 is different. See Telit Multiplxer SW User Guide for the
detailed information
Note: a software or hardware reset restores the default value.
Note: during cmux session the set command will return
ERROR, only the read and test command can be used.
Note: All CMUXMODE command will have no effect when M2M AT
Parser enabled (AT#M2MATP=1).
AT#CMUXMODE?
Read command returns the current value of <mode> parameter.
+CMUXMODE: <mode>
AT#CMUXMODE=?
Test command returns the range of supported values for parameter
<mode>