Telit Wireless Solutions LE910C series - Page 230

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 230 of 1904 2022-03-04
Not Subject to NDA
Need to reboot for new configuration.
Default password is "0123456789".
AT#SECIFCFG?
Read command returns the values in the following format:
#SECIFCFG: <sec_mask>
0 : No secure interface (No secure on all interface : default)
1 : Serial AT interface (secure AT access via USB, UART)
2 : Remote AT interface (secure AT access via TCP/IP, SMS)
3 : Serial and Remote AT interface (Secure AT access via USB, UART,
TCP/IP, SMS)
Ex)
AT#SECIFCFG?
#SECIFCFG: 1
OK
AT#SECIFCFG=?
Test command returns the range of supported values for all the
parameters.
AT#SECIFCFG=?
#SECIFCFG: (0-3),(10-16)
OK
Password is not displayed.