LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 259 of 1904 2022-03-04
When the indication is enabled, an unsolicited report with current
status (dormant or active) per packet call will be sent to the DTE.
Then, an update report sent to the DTE each time a change detected
on status.
Unsolicited result code for <action> 1:
#CDORM:<call_id>,<dormant_status>
Where: <dormant_status> -
0 - call is in dormant mode
1 - call is in active mode
AT#CDORM?
The read command returns the current settings and status.
#CDORM:<unsolicited_status>[,<call_id>,<dormant_status>][<CR><LF>
#CDORM:<unsolicited_status>[,<call_id>,<dormant_status>][...]]
Where: <unsolicited_status>
0 - call is in dormant mode
1 - call is in active mode
AT#CDORM=?
The test command returns the possible ranges of <action> and <call_id>
To Next Page
Loading...
