Telit Wireless Solutions LE910C series - Page 456

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 456 of 1904 2022-03-04
Not Subject to NDA
The definition for UE modes of operation can be found in 3GPP TS
24.301 [83]. Other values are reserved and will result in an ERROR
response to the set command.
AT+CEMODE?
Read command returns the current value of parameter <mode> in the
format:
+CEMODE: < mode >
The read command will return right values after set command, but
effectively the mode of operation changes after power cycle.
AT+CEMODE=?
Test command returns the supported range of values of parameters
<mode>.
Set EPS mode
AT+CEMODE=1
OK
Check EPS mode
AT+CEMODE?
+CEMODE: 1
OK