LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 535 of 1904 2022-03-04
<mode> parameter setting is stored in NVM and available at next
reboot. <mode>=3 is not saved.
If <mode>=1 or 4, the selected network is stored in NVM too and is
available at the next reboot (this will happen also after inserting
another SIM).
<mode>=5 is a value of 'read command' and not of 'set command'.
This is a transient state that occurs while a modem is initialized.
The network name can only be used among the list of network
names displayed by the +COPN command when using the manual
choice mode with alphanumeric format.
<format> parameter setting is never stored in NVM.
If AT+COPS=0 is issued after the switch-on, it causes a new
attempt to select a network operator and registers the module on
the selected operator.
AT+COPS?
Read command returns current value of <mode>, <format>, <oper> and
<AcT> in format <format>. If no operator is selected, <format>, <oper> and
<AcT> are omitted.
+COPS: <mode>[, <format>, <oper>,< act>]
If the module is deregistered, <format>, <oper>, and <act> parameters are
omitted.
A network name can be displayed with different name from showed
network name list by the +COPN command if the UE could get a
camped network name from USIM or network.
To Next Page
Loading...
Need help?
General
