Telit Wireless Solutions LE910C series At Commands Reference Guide

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 556 of 1904 2022-03-04
Not Subject to NDA
45
:
syntactical err in PKT filter
46
:
PDP context without TFT activated
47
:
multicast group membership timeout
48
:
retry on new cell begin (if MM cause failure) /
activation rejected BCM violation (if SM
cause failure)
50
:
PDP type IPV4 only allowed
51
:
PDP type IPV6 only allowed
52
:
single address bearers only allowed
63
:
retry on new cell end
81
:
invalid transaction identifier
95
:
semantically incorrect message
96
:
invalid mandatory information
97
:
MSG type non-existent or not implemented
98
:
MSG type not compatible with protocol state
99
:
IE non-existent or not implemented
100
:
conditional IE error
101
:
MSG not compatible with protocol state
111
:
protocol error unspecified
112
:
APN restriction value incompatible with
active PDP context
If none of this condition has occurred since power up then <code>
0: "Normal, unspecified" condition is reported.

Telit Wireless Solutions LE910C series Specifications

General

Brand	Telit Wireless Solutions
Model	LE910C series
Category	Wireless modules
Language	English