3.2.2.65. AT&V0 - Display Current Configuration and Profile 222
3.2.2.66. AT#FWSWITCH - Set Active Firmware Image 223
3.2.2.67. AT#FWAUTOSIM - Automatic Carrier Switch By SIM 227
3.2.2.68. AT#SECIFCFG - Secure Interface Configuration 229
3.2.2.69. AT#SECIFAUTH - Secure Interface Authentication 231
3.2.2.70. AT#SECIFPWD - Secure Interface Password 233
3.2.2.71. AT#CLATENA - Enable/Disable the CLAT interface 235
3.2.2.72. AT#CQI - HSDPA Channel Quality Indication 237
3.2.2.73. AT#FRATTRIGGER - Configure FRAT Trigger parameter 239
3.2.2.74. AT#PDPAUTH - PDP Authentication Parameters 241
3.2.2.75. AT#TXCAL4G - Change Max TX Power Level for a Supported Band 243
3.2.2.76. AT#TXCAL - TX Calibration 245
3.2.2.77. AT#CIND - Indication Control Reader Indication 247
3.2.2.78. AT#TID - Request Telit ID 249
3.2.2.79. AT+IMEISV - Request IMEI and Software Version Number 250
3.2.2.80. AT#CGMM - Request Model Identification 251
3.2.2.81. AT#IMSPDPSET - sets IMS Pdp APN Name 252
3.2.2.82. AT#FWTDEVICESET - Set FWT device for enabling 911 calling 253
3.2.2.83. AT#WKIO - Set RING CFG Parameters 255
3.2.2.84. AT#CDORM - Dormant control command 258
3.2.2.85. AT#CGMF - Request Product Code 260
3.2.3. S Parameters 261
3.2.3.1. ATS0 - Number of Rings to Auto Answer 261
3.2.3.2. ATS1 - Ring Counter 263
3.2.3.3. ATS2 - Escape Character 264
3.2.3.4. ATS3 - Command Line Termination Character 265
3.2.3.5. ATS4 - Response Formatting Character 267
3.2.3.6. ATS5 - Command Line Editing Character 269
3.2.3.7. ATS7 - Connection Completion Time-Out 270
3.2.3.8. ATS8 - Comma Dial Modifier Time 272
3.2.3.9. ATS10 - Carrier Off with Firm Time 273
3.2.3.10. ATS12 - Escape Prompt Delay 274
3.2.3.11. ATS25 - Delay to DTR Off 276
3.2.3.12. ATS30 - Disconnect Inactivity Timer 278
3.2.3.13. ATS38 - Delay To Before Forced Hang Up 279
3.2.3.14. AT&V1 - S Registers Display 281
3.2.3.15. AT&V3 - Extended S Registers Display 283
3.2.4. DTE - Modem Interface Control 284
3.2.4.1. ATE - Command Echo 284
To Next Page
Loading...
