Telit Wireless Solutions LE910C series - Page 753

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 753 of 1904 2022-03-04
Not Subject to NDA
This is a one-time configuration command, the configuration is
retained across reboots, power cycles, FOTA but not after XFP/TFI
update. The configuration must be done again after XFP/TFI
update.
AT#WLANMODULE?
Read command returns the current configured WLAN Module type
#WLANMODULE: <module_id>
Where:
<module_id>
0 - Module Type WE866C3
1 - Module Type WE866C6
AT#WLANMODULE=?
Test command reports supported range of values for all parameters.
at#wlanmodule?
#WLANMODULE: 0
OK