Telit Wireless Solutions LE910C series - Page 780

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 780 of 1904 2022-03-04
Not Subject to NDA
<APN>
string
-
(Access Point Name) a string
parameter which is a logical
name that is used to select the
GGSN or the external packet data
network. If the value is empty ("")
or omitted, then the subscription
value will be requested.
<PDP_addr>
string
-
A string parameter that identifies
the terminal in the address space
applicable to the PDP. The
allocated address may be read
using the +CGPADDR command.
<d_comp>
integer
0
Numeric parameter that controls
PDP data compression.
Values:
0
:
compression off
1
:
compression on
2
:
V.42bis
<h_comp>
integer
0
Numeric parameter that controls
PDP header compression.
Values:
0
:
compression off
1
:
compression on
2
:
RFC1144 (applicable for SNDCP only)
3
:
RFC2507
4
:
RFC3095 (applicable for PDCP only)
<IPv4AddrAlloc>
integer
0
a numeric parameter that
controls how the MT/TA requests
to get the IPv4 address
information.