Telit Wireless Solutions LE910C series - Page 788

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 788 of 1904 2022-03-04
Not Subject to NDA
AT#IMSSETTING=<mode>, read command is made for
parameter <mode>.
Default value of <SMS Over IP Network Indication> for ATT
firmware / Softbank firmware / Telstra firmware / Vodafone NZ
firmware are configured to '0' and for the others are '1'.
Default value of <sipt1>, <sipt2> and <sipt4> are based on operator
requirements.
AT#IMSSETTING?
Read command is not supported.
AT#IMSSETTING=?
Test command returns the supported range of <mode> in the format:
#IMSSETTING: (0-7),