Telit Wireless Solutions LE910C series - Page 790

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 790 of 1904 2022-03-04
Not Subject to NDA
Value:
0÷max
:
use test command to know the values
range
<peak>
integer
0
peak throughput class
Value:
0÷max
:
use test command to know the values
range
<mean>
integer
0
mean throughput class
Value:
0÷max
:
use test command to know the values
range
If a value is omitted for a class, then this class is not checked.
A special form of the set command, AT+CGQMIN=<cid> causes the
requested profile for context number <cid> to become undefined.
AT+CGQMIN?
Read command returns the current settings for each defined context in the
format:
+CGQMIN: <cid>,<precedence>,<delay>,<reliability>,<peak>,<mean>[<CR><LF>
+CGQMIN: <cid>,<precedence>,<delay>,<reliability>,<peak>,<mean>[...]]
If no PDP context has been defined, it has no effect and OK result code
is returned
AT+CGQMIN=?