Telit Wireless Solutions LE910C series - Page 796

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 796 of 1904 2022-03-04
Not Subject to NDA
0
:
subscribed value
1÷3
:
supported range
<Source
Statistics
Descriptor>
integer
0
specifies characteristics of the
source of the submitted SDUs for a
PDP context. This parameter should
be provided if the Traffic class is
specified as conversational or
streaming (refer 3GPP TS 24.008 [8]
subclause 10.5.6.5).
Values:
0
:
characteristics of SDUs is unknown
1
:
characteristics of SDUs corresponds to a
speech source
<Signalling
Indication>
integer
0
used to indicate signalling content of
submitted SDUs for a PDP context.
This parameter should be provided if
the Traffic class is specified as
interactive (refer 3GPP TS 24.008 [8]
subclause 10.5.6.5).
Values:
0
:
PDP context is not optimized for signalling
1
:
PDP context is optimized for signalling
a special form of the Set command, +CGEQREQ=<cid> causes the
requested profile for context number <cid> to become undefined.
AT+CGEQREQ?
Read command returns the current settings for each defined context in
the format: