Telit Wireless Solutions LE910C series - Page 802

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 802 of 1904 2022-03-04
Not Subject to NDA
PDP. The address may be static
or dynamic:
11. for a static address, it will
be the one set by the
+CGDCONT command
when the context was
defined
12. for a dynamic address it
will be the one assigned
during the last PDP context
activation that used the
context definition referred
to by <cid>; <PDP_addr> is
omitted if none is available
AT+CGPADDR=?
Test command returns a list of defined <cid>s.