Telit Wireless Solutions LE910C series - Page 822

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 822 of 1904 2022-03-04
Not Subject to NDA
omitted for a non-GBR QCI, see
standard [2].
<UL_GBR>
integer
-
indicates UL GBR in case of GBR QCI.
The value is in kbit/s. This parameter is
omitted for a non-GBR QCI, see
standard [2].
<DL_MBR>
integer
-
it indicates DL MBR in case of GBR QCI.
The value is in kbit/s. This parameter is
omitted for a non-GBR QCI, see
standard [2].
<UL_MBR>
integer
-
it indicates UL MBR in case of GBR QCI.
The value is in kbit/s. This parameter is
omitted for a non-GBR QCI, see
standard [2].
Additional info:
Possible Response(s):
+CME ERROR: <err>
AT+CGEQOS?
Read command returns the current settings for each defined QoS.
+CGEQOS: <cid>,
<QCI>,[<DL_GBR>,<UL_GBR>],[<DL_MBR>,<UL_MBR>][<CR>>LF>+CGEQOS:
<cid>, <QCI>,[<DL_GBR>,<UL_GBR>],[<DL_MBR>,<UL_MBR>][...]]
AT+CGEQOS=?
Test command returns the ranges of the supported parameters:
+CGEQOS: (list of supported <cid>s),(list of supported <QCI>s), (list of
supported <DL_GBR>s), (list of supported <UL_GBR>s), (list of supported
<DL_MBR>s),(list of supported <UL_MBR>s)