Telit Wireless Solutions LE910C series - Page 851

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 851 of 1904 2022-03-04
Not Subject to NDA
<p_cid>
integer
-
a numeric parameter which specifies a
particular PDP context definition which
has been specified by use of the
+CGDCONT command. The parameter is
local to the TE-MT interface. The list of
permitted values is returned by the test
form of the command.
<d_comp>
integer
0
controls PDP data compression
(applicable for SNDCPonly) (refer 3GPP
TS 44.065 [61])
Values:
0
:
off
1
:
on(manufacturer preferred compression)
2
:
V.42 bis
<h_comp>
integer
0
controls PDP header compression (refer
3GPP TS 44.065 [61] and 3GPP TS 25.323
[62]).
Values:
0
:
off
1
:
on(manufacturer preferred compression)
2
:
RFC1144 (applicable for SNDCP only)
3
:
RFC2507
4
:
RFC3095 (applicable for PDCP only)
AT+CGDSCONT?
The read command returns the current settings for each defined context
in the format:
+CGDSCONT: <cid>,<p_cid>,<d_comp>,<h_comp>[<CR><LF>
+CGDSCONT: <cid>,<p_cid>,<d_comp>,<h_comp> [...]]