LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 997 of 1904 2022-03-04
The volume <volume> is used
volume to be applied to the set of classes
of tones represented by <class>; it is
mandatory if <mode> is 1.
the value of max can be read issuing the Test
command AT#TSVOL=?
- The class DTMF Tones (<class>=16) refers only to the volume for
locally generated DTMF tones. It does not affect the level of the
DTMF generated by the network as result of AT+VTS command.
- The class signaling tones(<class>=8) effected on VoLTE signaling
tones only.
- The all classes does not effect on active voice call only AT+CLVL
value effected.
- The all classes except ringer tones(<class>= 2)/signaling
tones(<class>=8) are effected on analog mode only.
The ringer tones (<class>=2) is effected on analog and digital
mode.
The signaling tones(<class>=8) is effected on analog and digital
mode.
AT#TSVOL?
Read command returns for each class of tones the last setting of <mode>
and, if <mode> is not 0, of <volume> too, in the format:
#TSVOL: 1,<mode1>[,<volume1>]<CR><LF>
...
#TSVOL: 64,<mode64>[,<volume64>]
To Next Page
Loading...
Need help?
General
