Only <mode> 0 parameter is supported.
AT#ACDB[=<mode>]
Parameters:
<mode> - Inject mode
0 - Cold mode Injection. Audio Configuration is injected into FLASH.
In order to be effective a reboot is required.
After command line terminated with <CR>, We see the
intermediate result code CONNECT.
After this prompt, the file type must be in binary format.
If data successfully sent, then the response is OK.
If data sending fails for some reason, an error code reported.
AT#ACDB?
LE910Cx Linux:
Reports the supported range of <category> file.
#ACDB: (0-1),(0-7),(File Size)
LE910Cx ThreadX:
Report OK
OK
To Next Page
Loading...
