Telit Wireless Solutions LE910C series - Page 1117

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1117 of 1904 2022-03-04
Not Subject to NDA
4
:
enable Pull-Down if <dir>=0 - INPUT
<dir>
integer
0
GPIO pin direction
Refer to additional info for details of
Alternate functions.
Values:
0
:
Pin direction is INPUT
1
:
Pin direction is OUTPUT
2÷19
:
pin direction is Alternate Function
<save>
integer
0
GPIO pin save configuration
Values:
0
:
Pin configuration is not saved
1
:
Pin configuration is saved
Additional info:
when <save> is omitted the configuration is stored only if user set or
reset ALTx function on <dir> parameter.
When <mode>=2 (and <dir> is omitted), the command reports the
direction and value of GPIO<pin> in the format :
#GPIO: <dir>,<stat>
Reports a no meaning value if ALTERNATE FUNCTION