Telit Wireless Solutions LE910C series - Page 1157

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1157 of 1904 2022-03-04
Not Subject to NDA
- last <urcmode> settings are saved as extended profile parameters.
- GPIO is set to LOW when antenna is connected. Set to HIGH otherwise
- #GSMAD parameters, excluding <urcmode>, are saved in NVM.
AT#GSMAD?
Read command returns the current parameter settings for #GSMAD command in
the format:
#GSMAD:
<mod>,<urcmode>,<interval>,<detGPIO>,<repGPIO>,<antenna>,<adc><CR><LF>
#GSMAD: <mod>,<urcmode>,<interval>,<detGPIO>,<repGPIO>,<antenna>,<adc><C
R><LF>
#GSMAD:
<mod>,<urcmode>,<interval>,<detGPIO>,<repGPIO>,<antenna>,<adc><CR><LF>
AT#GSMAD=?
Test command reports the supported range of values for parameters <mod>,
<urcmode>, <interval>, <detGPIO>, <repGPIO>, <antenna> and <adc>.