Telit Wireless Solutions LE910C series - Page 1198

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1198 of 1904 2022-03-04
Not Subject to NDA
This command only works in ECM mode.
The parameters should be surrounded by quotes ex) "192.168.168.1" and the
value should be in proper format.
Validation of relationship between ip, netmask and gateway is not checked
when you set. it'll be checked when you execute AT#ECM command.
Provide a valid device name, otherwise the results could be not right.
If the User set Custom Address only and do not set device name, then
ERROR would be returned.
AT#ECMC?
Read command returns the last session configuration in the following format:
#ECMC:
<Did>,<State>,<Address>,<Address_Mask>,<Address_Gateway>,<Address_Dns1>,<
Address_Dns2>,<Address_Custom>,<Address_CustomMask>,<Address_CustomGat
eway>,<Address_CustomDns1>,<Address_CustomDns2>,<Mac_Address>,<Device_
Name>
...
OK
Additional info:
Parameters returned by the Read command and not described in the previous
sections.
Name
Type
Default
Description
<Did>
integer
0
device id