Telit Wireless Solutions LE910C series - Page 1199

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1199 of 1904 2022-03-04
Not Subject to NDA
Value:
0
:
currently 0
<State>
integer
N/A
State of ECM session.
Values:
0
:
disabled
1
:
enabled
<Current_Address>
string
-
Current IP Address
<Current_Address_Mask>
string
-
Current Net Mask
<Current_Address_Gateway>
string
-
Current address gateway
<Current_Address_Dns1>
string
-
Current Primary DNS
<Current_Address_Dns2>
string
-
Current secondary DNS
<Address_Custom>
string
-
User IP Address
<Address_CustomMask>
string
-
User IP Net Mask
<Address_CustomGateway>
string
-
User IP Gateway
<Address_CustomDns1>
string
-
User Primary DNS
<Current_Address_Dns2>
string
-
Current secondary DNS
<Device_Name>
string
-
Valid Device Name
"USER Setting" values will be adopted when you execute AT#ECM command.
In case of CURRENT Settings, void string will be shown if the value is not set,
for example: If there's no DNS value , then "CURRENT PRIMARY DNS" will
be " "