Telit Wireless Solutions LE910C series - Page 1237

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1237 of 1904 2022-03-04
Not Subject to NDA
<unused_C>
integer
-
reserved for future use
<noCarrierMode>
integer
0
select the NO CARRIER
message format received
when the socket is closed.
Values:
0
:
no additional information is attached to
NO CARRIER message
1
:
NO CARRIER: <connId> message
2
:
NO CARRIER: <connId>, <cause>
message. Refer to Additional info section
Additional info:
<noCarrierMode>=2 selects the following NO CARRIER message format:
NO CARRIER: <connId>, <cause>
Name
Type
Default
Description
<cause>
integer
-
is the socket disconnection cause.
Refer to #SLASTCLOSURE command to know
its values and meanings.
Is necessary to avoid overlapping of the two methods. Enabling new
method, the old method for transmission timer (#SCFG) is automatically
disabled to avoid overlapping.
Check if new data have been received from serial port is done with a
granularity directly related to <txTo> parameter which is set by #SCFG
command. The maximum period is 1 sec.
Like #SLASTCLOSURE, in case of subsequent consecutive closure causes
received, the original disconnection cause indicated.