LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1340 of 1904 2022-03-04
- the GPRS context 1 is correctly set with +CGDCONT
- the authentication parameters are set (#USERID, #PASSW) the GPRS
coverage is enough to permit a connection
- the GPRS has been activated with AT#GPRS=1
If all parameters omitted then the behaviour of Set command is the same
as Read command.
The main difference between this command and #SKTOP is that this
command does not interact with the GPRS context status, leaving it ON or
OFF according to the #GPRS setting, therefore when the connection made
with #SKTD is closed the context (and hence the local IP address) is
maintained.
AT#SKTD?
Read command reports the socket dial parameters values, in the format:
AT#SKTD: <socket type>,<remote port>,<remote addr>,<closure type>,<local
port>,<userIpType>
AT#SKTD=?
Test command returns the allowed values for the parameters.
To Next Page
Loading...
