To Next Page

To Previous Page

LE910Cx AT Commands Reference Guide

80502ST10950A Rev. 14 Page 1412 of 1904 2022-03-04

Not Subject to NDA

<cid>

intege

N/A

indicating the PDP Context Identifier.

Value:

0÷max

where the value of max is returned by the Test

Command

an ERROR is issued if <UNUSED_1> and <UNUSED_2> parameters are set

with a value different from 0.

a special form of the Set command, #HTTPCFG=<prof_id>, causes the

values for profile number <prof_id> to reset to default values.

For VZW products, default <cid> will be 3. The others will have 1 as default.

only one profile can use the SSL encryption.

HTTP AT command is supported the connection for IPv6 Server.

For WLAN, <UNUSED_1> is considered as <ssl_verify>, to enable or disable

CA certificate validation.

<UNUSED_1> parameter can be set to 0 or 1.

<UNUSED_2> parameter can be set only to 0.

HTTP AT command is supported the connection for IPv6 Server.

AT#HTTPCFG?

Read command returns the current settings for each defined profile in the format:

#HTTPCFG:<prof_id>,<server_address>,<server_port>,<auth_type>,<username>,<

password>,<ssl_enabled>,<timeout>,<cid>,0,0<CR><LF>[<CR><LF>

#HTTPCFG:<prof_id>,<server_address>,<server_port>,<auth_type>,<username>,<

password>,<ssl_enabled>,<timeout>,<cid>,0,0<CR><LF>

Telit Wireless Solutions LE910C series At Commands Reference Guide

Other manuals for Telit Wireless Solutions LE910C series