Telit Wireless Solutions LE910C series - Page 1531

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1531 of 1904 2022-03-04
Not Subject to NDA
followed by a Carriage Return) must be sent to
the module before the first AT command
1
:
When connection is up, the user receives a
request for username and, if username is
correct, a request for password. Then a
message of "Login successful" will close
authentication phase.
<retryCnt>
integer
0
in client mode, at boot or after a
socket disconnection, this
parameter represents the number
of attempts that are made to re-
connect to the Host.
Value:
0÷5
:
the number of attempts
<retryDelay>
integer
2
in client mode, delay between one
attempt and the other
Value:
1÷3600
:
delay in minutes
Unsolicited field:
Name
Type
Description
<urcmod>
integer
When unsolicited is enabled, an asynchronous TCP Socket
connection is indicated to TE with unsolicited result code:
#TCPATRUN: <iphostaddress>
When unsolicited is enabled, the TCP socket disconnection
is indicated to TE with unsolicited result code:
#TCPATRUN: <DISCONNECT>
Unsolicited is dumped on the instance that requested the
service activation.