Telit Wireless Solutions LE910C series - Page 1553

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1553 of 1904 2022-03-04
Not Subject to NDA
"GPIO2"
:
monitoring on a selected GPIO in
the GPIO range
"GPIO3"
:
monitoring on a selected GPIO in
the GPIO range
"GPIO4"
:
monitoring on a selected GPIO in
the GPIO range
"GPIO5"
:
monitoring on a selected GPIO in
the GPIO range
"ADCH1"
:
ADC High Voltage monitoring
"ADCL1"
:
ADC Low Voltage monitoring
"DTMF1"
:
monitoring on user defined DTMF
string
"DTMF2"
:
monitoring on user defined DTMF
string
"DTMF3"
:
monitoring on user defined DTMF
string
"DTMF4"
:
monitoring on user defined DTMF
string
"SMSIN"
:
monitoring on incoming SMS
<mode>
integer
0
disable/enable single event
monitoring
Values:
0
:
disable the single event monitoring
1
:
enable the single event monitoring
<paramType>
integer
0
Indicates the type of parameter
contained in <param>.
In particular, <paramType>=0
indicates that <param> contains the
AT command string to execute when
the related event has occurred. Here