Telit Wireless Solutions LE910C series - Page 1828

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 1828 of 1904 2022-03-04
Not Subject to NDA
Values:
0
:
disable IP (TCP or UDP) connection
1
:
TCP
2
:
UDP
<IP_addr:PORT
>
string
-
IPv4 server address with the socket port.
Number as string of 8bit ASCII Characters.
Max 25 chars
The configuration is stored in NVM.
Even though <URC> is set to 1 (enabled), URC is not presented to reduce
time taking on power down when <action> is 0 (disabled) on LE910C1-EUX,
LE910C1-SVX, LE910C1-SAX and LE910Cx-WWX.
AT#DGEN?
Read command returns the current Dying GASP setting according to the <action>
set, in the format:
#DGEN:
<GPIO>,<trigger>,<action>,<URC>[,<text>,<text_format>,[<SMSNum>][,<profile_id>
,<IP_protocol>,<IP_addr:PORT>]]
AT#DGEN=?
Test command reports the supported range of values of the command parameters.
<mode>,<GPIO>,<trigger>,<action>,<URC>,<text>,<text_format>,<SMSNum>,<profil
e_id>,<IP_protocol>,<IP_addr:PORT>