Telit Wireless Solutions LE910C series - Page 199

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 199 of 1904 2022-03-04
Not Subject to NDA
2
:
19200 bps
3
:
38400 bps
4
:
57600 bps
5
:
115200 bps
6
:
230400 bps
<N1>
integer
122
maximum frame size
Value:
1÷1500
:
maximum frame size
Additional info:
For models with the M2M AT Parser support, two command sets are
provided depending on the activation status of the M2M AT Parser.
AT#M2MATP=0 (M2M AT Parser disabled) - only <mode> and
<subset> parameters are supported.
AT#M2MATP=1 (M2M AT Parser enabled) -
<mode>, <subset>,<port_speed>,<N1> parameters are supported.
For M2M AT Parser not supported model, only <mode> and
<subset> parameters are supported.
Note: after entering the Multiplexed Mode an inactive timer of five
seconds starts. If no CMUX control channel is established before
this inactivity timer expires the engine returns to AT Command
Mode
Note: all the CMUX protocol parameter are fixed as defined in
GSM07.10 and cannot be changed.