To Next Page

To Previous Page

LE910Cx AT Commands Reference Guide

80502ST10950A Rev. 14 Page 225 of 1904 2022-03-04

Not Subject to NDA

This AT command is available on LE910Cx-NF, LE910Cx-AP,

LE910Cx-CN, LE910C1-NS, LE910Cx-WWX and LE910Cx-AP (SW

version 25.20.28x and 25.20.68x). Especially, LE910C1-AP only for

Telstra config don't support this AT command.

This AT command performs a system reboot and factory restore.

<storage_conf> setting value has no effect on firmware

configuration. It's only for the backward compatibility.

A current activated <net_conf> maintained, even if new firmware

updated and factory default value restored. For example, in case of

current <net_conf> is VZW, VZW config maintained when updating

new firmware.

If <restore_user_conf> parameter is set to 1, current user config is

stored before reboot, and then new user config restored on new

configuration at boot time. User config is stored and restored

separately per network config. User config indicates setting values

for the specific AT command set, which are listed as below:

+CGDCONT, +WS46, +COPS, #BND, #AUTOBND, #ENS, #SCFG,

#ENHSIM, #ICMP, #SMSMODE, #DNS, #SCFGEXT, #SSLCFG,

#SSLSECCFG, #SSLSECDATA, #SSLEN, #SGACTCFG,

#SGACTCFGEXT, #SCFGEXT2, #HTTPCFG, #SCFGEXT3,

#SMTPCFG, #PROTOCOLCFG

Softbank configuration is not available on .xx8 official version and

older version for commercial.

25.21.xx1 for LE910Cx-AP ( Japan ) support 3 network configs ( 10 =

NTT Docomo, 12 = KDDI, 13 = Softbank )

AT#FWSWITCH?

Read command reports the current active firmware image:

#FWSWITCH: <net_conf>,<storage_conf>,<restore_user_conf>

Telit Wireless Solutions LE910C series At Commands Reference Guide

Other manuals for Telit Wireless Solutions LE910C series