Telit Wireless Solutions LE910C series - Page 410

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 410 of 1904 2022-03-04
Not Subject to NDA
1
:
enable codec information unsolicited report only if
the codec changes, see info section
2
:
enable short codec information unsolicited report
only if the codec changes, see info section
Additional info:
<mode>=1, the unsolicited channel mode information is reported
according to the <format> parameter value:
if <format>=0, the URC is:
#CODECINFO: <codec_used>,<codec_set>
if <format>=1, the URC is:
#CODECINFO:
<codec_used>,<codec_set1>[,<codec_set2>[..[,codec_setn]]]
<mode>=2 the unsolicited codec information is reported in the
following format:
#CODECINFO: <codec_used>
The <codec_used> format depends on the <format> parameter
value.
Execution command (AT#CODECINFO<CR>) returns immediately
channels codecs information according to the previous setting of
<format> parameter.
if <format>=0, the return message is:
#CODECINFO: <codec_used>,<codec_set>
if <format>=1, the return message is: