To Next Page

To Previous Page

LE910Cx AT Commands Reference Guide

80502ST10950A Rev. 14 Page 432 of 1904 2022-03-04

Not Subject to NDA

#BCCHLOCK setting has higher priority than PLMN selection, that is why it

is not recommended to use this command together with manual PLMN

selection +COPS=1.

In the situation that LTE locked function is used so certain frequency and

PCI should be fixed, if the handover event comes down from the network or

it is in poor signal strength environment, the RLF may occur continuously.

Also, event if reselection event is happened on itself, it cannot move

another cells or frequencies. So, this function should be used carefully.

AT#BCCHLOCK?

Read command reports the currently stored parameter

<LockedBcch>,<LockedUarfcn>,<LockedPsc>,<LockedEarfcn> and <LockedPci> in

the format:

#BCCHLOCK:

If <LockedEarfcn> is set to 0, the related EFS would be removed so

<LockedPci> always returned 0 even if its value was input.

AT#BCCHLOCK=?

Test command reports the supported range of values for parameter

<LockedBcch>,<LockedUarfcn>,<LockedPsc>,<LockedEarfcn> and <LockedPci>.

Telit Wireless Solutions LE910C series At Commands Reference Guide

Other manuals for Telit Wireless Solutions LE910C series