Telit Wireless Solutions LE910C series - Page 520

LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 520 of 1904 2022-03-04
Not Subject to NDA
AT+CLIP?
Read command returns the presentation status of the CLI in the format:
+CLIP: <enable>,<status>
Additional info:
Parameters:
Name
Type
Default
Description
<enable>
integer
N/A
status of the local setting
Values:
0
:
CLI presentation disabled
1
:
CLI presentation enabled
<status>
integer
N/A
status of the CLIP service on the
network
Values:
0
:
CLIP not provisioned
1
:
CLIP provisioned
2
:
unknown (e.g. no network is present)
Read command issues a status request to the network, hence it
may take a few seconds to give the answer due to the time needed
to exchange data with it.
AT+CLIP=?
Test command returns the supported values of parameter <enable>.