LE910Cx AT Commands Reference Guide
80502ST10950A Rev. 14 Page 690 of 1904 2022-03-04
The module keeps on playing the alarm tone until a #WAKE or
#SHDN command is received or a 90 s time-out occurs. If the device
is in "alarm mode" and it does not receive the #WAKE command
within 90s then it shuts down.
If alarm expires during a call alarm sound will stop when the call is
disconnected.
<type>=4
The module wakes up in "alarm mode" if at the alarm time it was
off, otherwise it remains fully operative. In both cases the module
brings the alarm pin high, provided that one has been set (using
#ALARMPIN or #GPIO) and keeps it in this state until a #WAKE or
#SHDN command is received or a 90 seconds timer expires. If the
device is in "alarm mode" and it does not receive the #WAKE
command within 90s then it shuts down.
<type>=5
The module will make both the actions as for <type>=2 and
<type>=3.
<type>=6
The module will make both the actions as for <type>=2 and <type>=4.
<type>=7
The module will make both the actions as for <type>=3 and <type>=4.
To Next Page
Loading...
